zephyr/boards/st/nucleo_g0b1re/nucleo_g0b1re_defconfig

# Enable MPU
CONFIG_ARM_MPU=y

# Serial Drivers
CONFIG_SERIAL=y
CONFIG_UART_INTERRUPT_DRIVEN=y
# enable console
CONFIG_CONSOLE=y
CONFIG_UART_CONSOLE=y

# GPIO Controller
CONFIG_GPIO=y

# Enable Clocks
CONFIG_CLOCK_CONTROL=y

# enable pin controller
CONFIG_PINCTRL=y
board: arm: add support for the nucleo_g0b1re board Support for the nucleo_g0b1re. Signed-off-by: Thomas Stranger <thomas.stranger@outlook.com> 2020-12-30 22:52:04 +01:00			`# Enable MPU`
			`CONFIG_ARM_MPU=y`

			`# Serial Drivers`
			`CONFIG_SERIAL=y`
			`CONFIG_UART_INTERRUPT_DRIVEN=y`
			`# enable console`
			`CONFIG_CONSOLE=y`
			`CONFIG_UART_CONSOLE=y`

			`# GPIO Controller`
			`CONFIG_GPIO=y`

boards: nucleo_g0b1re: Use dts for clocks configuration Convert board to use of device tree for clocks configuration. Signed-off-by: Alexandre Bourdiol <alexandre.bourdiol@st.com> 2021-05-03 14:50:10 +02:00			`# Enable Clocks`
board: arm: add support for the nucleo_g0b1re board Support for the nucleo_g0b1re. Signed-off-by: Thomas Stranger <thomas.stranger@outlook.com> 2020-12-30 22:52:04 +01:00			`CONFIG_CLOCK_CONTROL=y`
boards: arm: stm32: enable pinctrl driver Enable the pin control driver on all STM32 based boards. The following script has been used to do this task: ``` from pathlib import Path import re for fpath in Path(".").glob("boards/arm/*/_defconfig"): lines = open(fpath).readlines() is_stm32 = False for line in lines: if "CONFIG_SOC_SERIES_STM32" in line: is_stm32 = True break if not is_stm32: continue lines += ["\n", "# enable pin controller\n", "CONFIG_PINCTRL=y\n"] with open(fpath, "w") as f: f.writelines(lines) ``` Signed-off-by: Gerard Marull-Paretas <gerard.marull@nordicsemi.no> 2021-09-30 15:32:01 +02:00
			`# enable pin controller`
			`CONFIG_PINCTRL=y`