Added new CC1352P1 LaunchXL board supporting 20dBm TX for its
sub-GHz radio.
Note that the board has a multiplexer circuit to switch between
2.4GHz, High-Power TX and Sub1GHz states, for which a custom board
module was implemented, together with board-specific device-tree
bindings and pinctrl definitions for each of the RF states.
Signed-off-by: Stancu Florin <niflostancu@gmail.com>
Enhance IEEE802154 Sub-GHz driver to support CC13x2P's internal power
amplifier (20dBm) for TX.
Note: requires board-specific antenna switching for it to work
properly.
Signed-off-by: Stancu Florin <niflostancu@gmail.com>
Many device pointers are initialized at compile and never changed. This
means that the device pointer can be constified (immutable).
Automated using:
```
perl -i -pe 's/const struct device \*(?!const)(.*)= DEVICE/const struct
device *const $1= DEVICE/g' **/*.c
```
Signed-off-by: Gerard Marull-Paretas <gerard.marull@nordicsemi.no>
Use Devicetree to describe the radio and IEEE 802.15.4. This allows to
remove usage of IEEE802154_CC13XX_CC26XX_SUBG_DRV_NAME in preparation
for the removal of NET_CONFIG_IEEE802154_DEV_NAME.
Signed-off-by: Gerard Marull-Paretas <gerard.marull@nordicsemi.no>
In order to bring consistency in-tree, migrate all drivers to the new
prefix <zephyr/...>. Note that the conversion has been scripted, refer
to #45388 for more details.
Signed-off-by: Gerard Marull-Paretas <gerard.marull@nordicsemi.no>
Replace all get_dev_data()/get_dev_config() accessor utilities with
dev->data and dev->config.
Signed-off-by: Gerard Marull-Paretas <gerard.marull@nordicsemi.no>
When stopping the interface, also abort the RX routine and enable RF
power saving. Will re-start RX on iface start.
Also fixed a bug with `cmd_fs` crashing at RF wakeup because `rf_mode`
was allocated on stack.
Signed-off-by: Stancu Florin <niflostancu@gmail.com>
Convert drivers to DEVICE_DEFINE instead of DEVICE_AND_API_INIT
so we can deprecate DEVICE_AND_API_INIT in the future.
Signed-off-by: Kumar Gala <kumar.gala@linaro.org>
This change adds IEEE802154_RAW_MODE support for the
cc1352r.
This allows using the cc1352r 2.4 GHz radio and Sub Ghz
radio as a transceiver (PHY) instead of using L2 networking.
Signed-off-by: Erik Larson <erik@statropy.com>
This change adds IEEE 802.15.4g (Sub GHz) support for the
cc1352r.
The 2.4 GHz radio and the Sub GHz radio are capable of
operating simultaneously.
Fixes#26315
Signed-off-by: Christopher Friedt <chrisfriedt@gmail.com>
