In order to bring consistency in-tree, migrate all drivers to the new
prefix <zephyr/...>. Note that the conversion has been scripted, refer
to #45388 for more details.
Signed-off-by: Gerard Marull-Paretas <gerard.marull@nordicsemi.no>
According to Kconfig guidelines, boolean prompts must not start with
"Enable...". The following command has been used to automate the changes
in this patch:
sed -i "s/bool \"[Ee]nables\? \(\w\)/bool \"\U\1/g" **/Kconfig*
Signed-off-by: Gerard Marull-Paretas <gerard.marull@nordicsemi.no>
The driver was re-using the display log level, however, it is no longer
part of the display driver category.
Signed-off-by: Gerard Marull-Paretas <gerard.marull@nordicsemi.no>
- Cleanup list of includes
- Remove unused structs/definitions
- Make init function static (is called by system init)
- Make config/data naming and access consistent
- Remove redundant zero initialization of data
Signed-off-by: Gerard Marull-Paretas <gerard.marull@nordicsemi.no>
The driver is sleeping in milliseconds using a custom wrapper around
k_busy_wait, move to k_sleep.
Signed-off-by: Gerard Marull-Paretas <gerard.marull@nordicsemi.no>
Modernize the driver a little bit by using i2c_dt_spec. Note that the
RGB on its own is another I2C device connected to the same bus. Ideally,
both should be defined in Devicetree, but this has not been done for
now.
Signed-off-by: Gerard Marull-Paretas <gerard.marull@nordicsemi.no>
The driver was never migrated to Devicetree, this patch converts the
driver to a proper Devicetree based device.
Signed-off-by: Gerard Marull-Paretas <gerard.marull@nordicsemi.no>
The driver does not implement a display API, it has a custom API. Having
it under display is confusing, since display API consumers may expect
they can use it. These sort of custom drivers fit better under
drivers/misc.
Signed-off-by: Gerard Marull-Paretas <gerard.marull@nordicsemi.no>
Some drivers explicitely casted data/config from void * to the
corresponding type. However, this is unnecessary and, in many drivers it
has been misused to drop const qualifier (refer to previous commits).
Signed-off-by: Gerard Marull-Paretas <gerard.marull@nordicsemi.no>
This patch includes initial support for FT800 display driver.
It includes basic features. It can be easily extended with more
FT800 display list and co-processor features.
Signed-off-by: Hubert Miś <hubert.mis@gmail.com>
