Do not allow the modem to sleep if the driver is busy.
Fix CTS filtering. Ignore small pulses on the CTS line.
Fix socket restoration. Restored sockets could be mismatched
with a wrong type.
UDP sockets could be duplicated during restore.
Improve IO debug mode. Use warning message for IO debug mode
to easily see IO transitions color coded in a terminal.
Ensure the UART is enabled whenever the driver needs to send
commands to the modem.
Ensure DNS resolver is re-initialized after the modem is powered off.
PROD-307
Signed-off-by: Ryan Erickson <ryan.erickson@lairdconnect.com>
Ensure the driver enables the LTE radio during init unless boot
in airplane mode is specified.
To ensure the settings applied during init are used, the LTE radio
is turned off during config.
Fix issue where PDP and GPRS connection config could have a mismatched APN.
Signed-off-by: Ryan Erickson <ryan.erickson@lairdconnect.com>
According to Kconfig guidelines, boolean prompts must not start with
"Enable...". The following command has been used to automate the changes
in this patch:
sed -i "s/bool \"[Ee]nables\? \(\w\)/bool \"\U\1/g" **/Kconfig*
Signed-off-by: Gerard Marull-Paretas <gerard.marull@nordicsemi.no>
Use CTS input to monitor HL7800 sleep state
when in SLEEP mode.
When CTS is high, shutdown the UART to
save power.
Signed-off-by: Ryan Erickson <ryan.erickson@lairdconnect.com>
Position over LTE (PoLTE) can be used to locate a device as
an alternative to GNSS.
Increase RX thread stack size for PoLTE processing.
Signed-off-by: Ryan Erickson <ryan.erickson@lairdconnect.com>
Allow application control for starting modem driver.
This allows network attach to be randomized.
Signed-off-by: Ryan Erickson <ryan.erickson@lairdconnect.com>
The driver utilizes the CONFIG_NET_OFFLOAD setting to avoid the
normal handling of IP packets, and instead uses a socket-like
UART interface to handle incoming and outgoing data via AT commands.
Signed-off-by: Ryan Erickson <ryan.erickson@lairdconnect.com>
