353c6a66cb
Remove ethernet-fixed-link binding as it is redundant with the phy bindings. Clearly, ethernet does not work without the L1 layer, which is a phy device, or an integrated mac/phy device, and all of these things should be described properly in DT. The schema did not even come with a compatible, meaning nodelabels were hardcoded into the drivers, which is unacceptable. - Remove the binding file for ethernet-fixed-link.yaml. - Remove fixed link functionality from the nxp s32 gmac driver. Since this functionality is already covered by the phy support, it is redundant. - Remove fixed link include from the s32 gmac binding. - Remove fixed link include from the nuvoton numaker binding. As far as I can tell the corresonding driver does not even use it anyways, and I did not find any board with this device that describes a "fixed link". - Move the definition into the nxp,kinetis-ethernet binding as the eth_mcux driver, which is already being deprecated, does use this, contain the debt to the legacy driver. Signed-off-by: Declan Snyder <declan.snyder@nxp.com>
40 lines
913 B
YAML
40 lines
913 B
YAML
# Copyright (c) 2018, Linaro Limited
|
|
# SPDX-License-Identifier: Apache-2.0
|
|
|
|
description: NXP Kinetis Ethernet
|
|
|
|
compatible: "nxp,kinetis-ethernet"
|
|
|
|
include: ["ethernet-controller.yaml", "pinctrl-device.yaml"]
|
|
|
|
properties:
|
|
reg:
|
|
required: true
|
|
interrupts:
|
|
required: true
|
|
phy-addr:
|
|
type: int
|
|
description: Address of the phy controller
|
|
required: true
|
|
reset-gpios:
|
|
type: phandle-array
|
|
description: GPIO to reset PHY. Reset signal is assumed active low.
|
|
int-gpios:
|
|
type: phandle-array
|
|
description:
|
|
interrupt GPIO for PHY. Will be pulled high before reset is asserted.
|
|
|
|
child-binding:
|
|
description: Fixed link ethernet node
|
|
properties:
|
|
speed:
|
|
type: int
|
|
required: true
|
|
description: The speed of fixed link
|
|
enum:
|
|
- 100
|
|
- 10
|
|
full-duplex:
|
|
type: boolean
|
|
description: The fixed link operates in full duplex mode
|