Ben Lauret 9cdc5d38b2 drivers: spi: Add driver for smartbond ... This adds the SPI driver for the Renesas SmartBond(tm) DA1469x MCU family. The driver only supports controller mode. All four SPI modes are supported. Note that the lowest supported speed is 2285714Hz. Requesting speeds higher than 16MHz, will result in a 16MHz SCLK. Co-authored-by: Stan Geitel <stan@geitel.nl> Signed-off-by: Ben Lauret <ben.lauret.wm@renesas.com>		2023-04-20 10:32:40 +02:00
..
arc/synopsys	dts: boards :emsdp: add SPI support	2023-03-10 11:39:24 +01:00
arm	drivers: spi: Add driver for smartbond	2023-04-20 10:32:40 +02:00
arm64	board: arm64: fvp_baser_aemv8r: Add ethernet, phy and mdio nodes	2023-04-11 11:27:05 +02:00
bindings	drivers: spi: Add driver for smartbond	2023-04-20 10:32:40 +02:00
common	dts/arm: stm32: Add clocks nodes on stm32wb,l4 and stm32f4 series	2021-04-27 11:53:37 +02:00
nios2/intel	dts: nios2: intel: nios2-qemu: add jtag interrupt	2023-01-27 14:24:43 -05:00
posix	dts: posix: Add DTS support for POSIX architecture	2019-05-28 21:14:19 -04:00
riscv	ITE: dts: it82xx2: Increase sram to 256KB	2023-04-19 03:48:38 -04:00
sparc/gaisler	dts: sparc: Remove label property from devicetrees	2022-07-22 02:51:14 -05:00
x86/intel	dts: x86: intel: raptor_lake: Added UART instances	2023-03-30 09:43:29 -04:00
xtensa	soc: esp32s3: add Wi-Fi support	2023-04-19 17:11:58 +02:00
binding-template.yaml	doc: devicetree: overhaul bindings guide	2021-04-22 15:32:10 +02:00
Kconfig	dts: Include Kconfig.dts as optional source	2022-08-15 11:10:51 -07:00