Utilize a code spell-checking tool to scan for and correct spelling errors
in all files within the dts/bindings/net, power-domain, pwm and qspi.
Signed-off-by: Pisit Sawangvonganan <pisit@ndrsolution.com>
The NXP S32 QSPI controller acts as an interface to up to two serial
flash memory devices, each with up to eight bidirectional data lines,
depending on the platform. It is based on a LUT enginee to interface
through commands with different memory types including flash NOR and
Hyperram.
This patch adds support for the QSPI in S32K344 which supports a single
memory device (side A) with up to four bidirectional data lines and SDR
only. Nevertheless, the memory controller is implemented flexible enough
to be extended to support more feature-rich QSPI blocks.
Signed-off-by: Manuel Argüelles <manuel.arguelles@nxp.com>
Give precision to the description of the dma phandle in the
quadspi node.
When a DMAMUX is present and enabled, the channel is the dma one
(not dmamux channel) and the request is given by the DMAMUX.
Signed-off-by: Francois Ramu <francois.ramu@st.com>
DTS property attributes are (by default) not required.
Explicitly specifying `required: false` is redundant.
Perhaps a warning to that effect would be useful.
Signed-off-by: Chris Friedt <cfriedt@meta.com>
Add dts bindings for the NIOS2 QSPI controller and flash device and
add nodes to the dts files for these devices as well.
Signed-off-by: Kumar Gala <galak@kernel.org>
The 'flash-id' property defines the number of QSPI's dedicated GPIO
bank (and flash ID), which will be used to communicate with flash
memory.
For example, on stm32h7xx it is possible to use 'quadspi_bk1_*' and
'quadspi_bk2_*' set of pins, so one may need to select between them
when required.
By default - pins from 'quadspi_bk1_*' bank are used, so the
'flash-id = <2>;' property, when your use case (e.g. PCB design)
requires it, forces usage of 'quadspi_bk2_*' pins.
Signed-off-by: Lukasz Majewski <lukma@denx.de>
Now that STM32 drivers are using pinctrl API, set pintrl-0 and
pintrl-names properties as required in order to report malformed
nodes description soon at build stage and avoid cryptic
DT api build error messages.
Signed-off-by: Erwan Gouriou <erwan.gouriou@linaro.org>
In order to ease reuse on other series, set DMA as optional
and use IT if no DMA channel is specified in the qspi node.
Tested on disco_l475_iot1
Signed-off-by: Erwan Gouriou <erwan.gouriou@linaro.org>
