zephyr/dts/arm
Daniel DeGrasse 5957da5830 dts: arm: nxp: rt1064: setup rx-clock-source for XIP flash
Setup rx-clock-source for XIP flash. When running from RAM, the FLEXSPI2
attached SIP flash will be reconfigured, so we must ensure the
configuration used for it is valid.

Signed-off-by: Daniel DeGrasse <daniel.degrasse@nxp.com>
2024-02-01 10:57:35 +01:00
..
acsip dts: arm: Remove label property from devicetrees 2022-07-27 18:48:10 +02:00
ambiq boards: arm: apollo4p_evb Shield Support 2024-01-26 12:36:40 +01:00
aspeed dts: arm: aspeed: add AST10X0 system reset control 2022-12-05 14:36:16 +01:00
atmel drivers: flash: sam: Use interrupt to sync 2024-01-23 15:22:26 +00:00
broadcom dts: arm: Blanket remove all usages of arm,num-mpu-regions 2023-12-01 10:48:00 +00:00
cypress dts: psoc6: move pinctrl subdevices up a node 2023-10-25 18:39:31 -07:00
gd dts: arm/riscv: gigadevice: s/gigadevice/gd 2024-01-10 20:59:21 -05:00
infineon drivers: can: Add xmc4xxx CAN support 2024-01-30 19:06:06 +01:00
intel_socfpga_std drivers: spi: dw: define max-xfer-size 2024-01-20 13:11:42 +01:00
microchip dts: mec1727nsz: fix few build issues 2023-10-23 16:33:45 +01:00
nordic dts: bindings: arm: nordic,nrf-ficr: add #nordic,ficr-cells 2024-01-31 13:40:59 +00:00
nuvoton drivers: spi: npcx: add driver for the SPI peripheral 2024-01-11 10:04:21 +01:00
nxp dts: arm: nxp: rt1064: setup rx-clock-source for XIP flash 2024-02-01 10:57:35 +01:00
olimex dts: Add power-amplifier properties to STM32WL boards/modules 2023-04-24 13:33:25 +02:00
quicklogic dts: arm: Blanket remove all usages of arm,num-mpu-regions 2023-12-01 10:48:00 +00:00
renesas dts: arm: renesas: Move rz dtsi to range folder 2024-01-30 09:59:54 +01:00
rpi_pico drivers: clock_control: Added clock driver for Raspberry Pi Pico 2023-12-20 11:14:24 +01:00
seeed dts: Add power-amplifier properties to STM32WL boards/modules 2023-04-24 13:33:25 +02:00
silabs dts: arm: silabs: Add Support for Silabs MG12 BRD4161A board 2024-01-30 08:46:25 +01:00
st dts: arm: stm32wba: add standby mode to device tree 2024-01-30 18:01:00 +01:00
ti dts: arm: ti: am62x_m4: Add gpio0 node 2023-11-13 09:42:11 +01:00
xilinx drivers: pinctrl: Add ZynqMP / Mercury XU pinctrl support 2024-01-26 12:47:11 +01:00
armv6-m.dtsi dts: arm: Add #address-cells to nvic nodes 2021-08-02 15:02:09 -04:00
armv7-a.dtsi soc: arm: dts: arm: xilinx: Zynq-7000 SoC init code, device tree data 2021-10-28 15:26:50 +02:00
armv7-m.dtsi dts: arm: Add #address-cells to nvic nodes 2021-08-02 15:02:09 -04:00
armv7-r.dtsi arch: arm: Fix incorrect Cortex-R device tree specification. 2019-10-11 16:27:14 +02:00
armv8-m.dtsi dts: arm: Add #address-cells to nvic nodes 2021-08-02 15:02:09 -04:00
armv8-r.dtsi dts: arm: add ARMv8-R skeleton 2022-10-14 09:51:14 +02:00
armv8.1-m.dtsi dts: arm: Add #address-cells to nvic nodes 2021-08-02 15:02:09 -04:00