The number of IRQ priority bits was incorrectly set to 3 instead
of 2, which is the correct number for Cortex-M0+.
Signed-off-by: Yonatan Schachter <yonatan.schachter@gmail.com>
Added a generic driver for RaspberryPi Pico PIO.
This driver is an intermediate driver for abstracting the PIO
device driver from physical pin configuration.
Signed-off-by: TOKITA Hiroshi <tokita.hiroshi@fujitsu.com>
Signed-off-by: Yonatan Schachter <yonatan.schachter@gmail.com>
Signed-off-by: Ionut Catalin Pavel <iocapa@iocapa.com>
The addresses of the flash and flash controller of the RP2040
SoC were mixed up. There was no clear distinction between the
flash and the flash controller, which was unclear but also
caused a DTC warning.
This commit makes the distinction clearer: The SSI peripheral at
0x18000000 is the flash controller, and the flash itself starts
at 0x10000000. The flash driver and rpi_pico.dts were fixed
accordingly.
Signed-off-by: Yonatan Schachter <yonatan.schachter@gmail.com>
The pinctrl node of the RP2040 had the same unit address as the GPIO
bank, causing a DTC warning. To fix this, the pinctrl's address was
removed, as it does not require any.
Signed-off-by: Yonatan Schachter <yonatan.schachter@gmail.com>
Define RaspberryPi Pico ADC.
The ADC has internally connected temperature sensor,
Add property to enable this.
The ADC has a single VREF. VCC usually connects to it,
but it may not be in a case.
Add property to make configurable it.
Signed-off-by: TOKITA Hiroshi <tokita.hiroshi@fujitsu.com>
Add spi0 and spi1 configuration to rp2040.
spi0 and spi1 are declared as compatible with
"raspberrypi,pico-spi" and "arm,pl022".
"raspberrypi,pico-spi" is just inherited from
"arm,pl022" and "reset-device"
spi0 and spi1 declare as compatible with "raspberrypi,pico-spi"
and "arm,pl022".
"raspberrypi,pico-spi" is just inheriting "arm,pl022" and
"reset-device" for declaring the 'reset' property,
with no additional property and implementation.
Add also pinctrl macros to dt-bindings header.
Signed-off-by: TOKITA Hiroshi <tokita.hiroshi@fujitsu.com>
This adds basic support for the watchdog timer on the RP2040 MCU and
Raspberry Pi Pico development board
Signed-off-by: Jamie McCrae <spam@helper3000.net>
In order to bring consistency in-tree, migrate all dts code to the new
prefix <zephyr/...>. Note that the conversion has been scripted, refer
to zephyrproject-rtos#45388 for more details.
Signed-off-by: Gerard Marull-Paretas <gerard.marull@nordicsemi.no>
Properly set both pull up and down flags explicitly when
making changes.
Properly implement disabling interrupts on a given pin.
Signed-off-by: Peter Johanson <peter@peterjohanson.com>
Added basic support for the RP2040 SoC. Support
includes booting and starting the kernel, on one
core only.
Signed-off-by: Yonatan Schachter <yonatan.schachter@gmail.com>
Signed-off-by: Ioannis Glaropoulos <Ioannis.Glaropoulos@nordicsemi.no>
