Nuvoton NPCX chips have reset registers which allow to reset the
peripheral hardware modules. This commit adds the support by
implementing the reset driver. Note that only the reset_line_toggle API
is supported because of the nature of the reset controller's design.
Signed-off-by: Jun Lin <CHLin56@nuvoton.com>
Copy the DMA channel information to both UART and SPI
instances of the Flexcomm as only one of them can be
active.
Signed-off-by: Mahesh Mahadevan <mahesh.mahadevan@nxp.com>
CSS was deprecated from the mcu-sdk. Removing driver from lpc55s36
to clear build error.
This is a temporary patch to remove the build error.
Fixes#69961
Signed-off-by: David Leach <david.leach@nxp.com>
Add definitions of PWM peripheral instances so it can be utilized
on nRF54H20 and nRF54L15 devices.
Signed-off-by: Nikodem Kastelik <nikodem.kastelik@nordicsemi.no>
Add EDMA channels for LPUART RX and TX to LPFLEXCOMM 2 and 4, as these
nodes are enabled with the UART driver
Signed-off-by: Daniel DeGrasse <daniel.degrasse@nxp.com>
Enable sleep mode on LPC55S69 (corresponding to zephyr's runtime idle
mode). Add DT description and power api implementations.
Signed-off-by: Declan Snyder <declan.snyder@nxp.com>
Add common gpio node to pinctrl node (interrupts are shared between ports)
and syscon for interrupt edge detection register in order to support
interrupts in rzt2m gpio
Signed-off-by: Jakub Michalski <jmichalski@internships.antmicro.com>
"RW pinctrl" is clearly SOC specific naming for an IP
that is not necessarily constrained to live on one SOC series.
Signed-off-by: Declan Snyder <declan.snyder@nxp.com>
There were missing global dppic and ipct channels configuration
that allows to deliver events from global peripherlas like GRTC
to Radio domain.
Add missing configuration to nrf54h20 dtsi file.
Signed-off-by: Piotr Pryga <piotr.pryga@nordicsemi.no>
The GRTC channels and irqs configuration for Radio domain
is SOC specific not board specific. Move the configuration
to SOC dtsi file.
Signed-off-by: Piotr Pryga <piotr.pryga@nordicsemi.no>
The child-owned-channels property of GRTC is used by nrfx_grtc
driver to exclude channels for common pool of channels allowed
for dynamic allocation. That is sort-of workaround for missing
property that allowes to remove some channels from the pool.
There are also not aligned GRTC IRQs for nRF54H20 and nRF54L15.
Only one of avaialbe IRQs was added to GRTC in DTS whereas
there should be two. That allows to find second IRQ by other
drivers that use GRTC peripehral.
Signed-off-by: Piotr Pryga <piotr.pryga@nordicsemi.no>
Add definition of the nRF54H20 SoC with its Application, Radio,
and Peripheral Processor (PPR) cores and an initial set of
peripherals.
Signed-off-by: Andrzej Głąbek <andrzej.glabek@nordicsemi.no>
Remove all optional, initial CAN sample point properties and rely on the
CAN timing calculations to automatically pick the preferred sample point
location based on the initial bitrate.
Signed-off-by: Henrik Brix Andersen <hebad@vestas.com>
